Click image to view full size image
LED soft film advertising lightbox composed of sapless aluminum alloy frame, LED module light source, and soft film cloth。
Flexible film light box The LED strips are arranged neatly and beautifully. Using constant current circuit, the structure is safe and simple, no ultraviolet rays, no infrared rays, no stroboscopic phenomena, and green environmental protection. The screen of the soft film light box can be installed with elastic cloth, woven cloth, or ceiling soft film seam silicone strip, which can quickly change the screen, and the screen is guaranteed not to fade within 5 years.
The soft film light box is easy to install and use. The LED energy-saving lamp beads used are a very energy-saving and environmentally friendly product.
The soft film light box has the characteristics of being resistant to aging, rusting, and convenience. Due to the adoption of some anti-aging and corrosion materials, the service life is increased. It is a new generation of environmentally friendly energy-saving light box products.
LED Soft Film Advertising Lightbox Installation steps:1. Before installing the soft film light box, first go to the construction site to see if the conditions are met, whether the installation wall has a stress point, and different wall installation methods are different
2. If the site conditions are met, the construction will be carried out first, and the finished soft film light box must be made according to the design requirements of the soft film light box drawing.
3. Prepare the soft film aluminum profiles and accessories (large angle code/small angle code) base plate, power supply, light cloth, other tools (screwdriver/screw/tape/gloves) and other materials.
4. According to the 45-degree angle, first combine the soft film profiles with the frame, and put the corners together, and check whether the diagonals of the soft film profiles are the same.
5. Tighten the screws on the inner and outer corners with a screwdriver to ensure that the diagonals are equal, and the screws have a fixed effect, so that the entire soft film light box frame is completed
6. Put the back panel into the frame and fix it with screws, then lay the LED strip on the back panel, fix it with double-sided tape or screws, and install the power supply on the edge of the frame where the wires go out (the red and blue wires are connected separately)
7. Install the soft film light box on the wall according to the requirements, and fasten the four sides with screws according to the actual situation.
8. Install the canvas, put the silicone strip around the UV soft film (fixed when making the picture), press it into the aluminum frame card slot by hand, change the picture and pull out the rubber strip. This way, stylish and simple design, easier to replace
9. It is to check the overall effect of the soft film light box picture, adjust the picture tightness according to the situation, and achieve the most ideal effect.
http://www.zonesutech.com/
E-mail: 